Product Description
Rust-Oleum® Acrylic Enamel
Choose your colours!
Choose Any Of the Following:
- 271903 - Gloss Black 340g
- 271915 - Semi Gloss Black 340g
- 271918 - Flat Black 340g
- 271919 - Gloss White 340g
- 271913 - Gloss Clear 340g
ABOUT ACRYLIC ENAMEL
Rust-Oleum® Acrylic Enamel is a premium acrylic finish designed to provide fast dry, excellent coverage and maximum durability. It is suitable for use on metal and wood and can be used indoors or outdoors. Acrylic Enamel features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
PRIMING
Use of a Rust-Oleum primer provides added corrosion protection, enhances adhesion and hiding, and is especially recommended for metal and wood surfaces.
Recommended primers include:
- 7769830 Rusty Metal Primer Aerosol can
- 7780830 Clean Metal Primer Aerosol can
- 2081830 Flat Light Gray Auto Primer Aerosol can
Wash the surface with a commercial detergent, or other suitable cleaning method to remove dirt. Rinse with fresh water and dry with a clean cloth. Remove all oil, grease, wax and petroleum based materials with mineral spirits. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces. WARNING: If you scrape, sand, or remove old paint
APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 10-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 20 minutes, to handle in 1 hour and is fully dry in 24 hours. Apply a second coat or Clear Coat within 1 hour or after 48 hours.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.
**Please Note**
This item can only be sent by Road
Express Shipping & Air Shipping is not available